Alka-Brite + 4X Concentrate

Alka-Brite + 4X Concentrate

SKU: 4120-90

Cuts through greasy dirt better than acids

Cleans and brightens

Foaming helps lift out stubborn soils

Available in traditional and concentrate formulas

Biodegradable

Product Description

A non-acid, alkaline-based product for brightening and cleaning air-cooled condensers. It contains the best available detergents and surfactants to quickly penetrate and remove greasy soils and oxidation and its foaming helps lift greasy soils out of the coil, leaving equipment clean and bright.

For cleaning and brightening air cooled condensers, permanent filters and other finned heating and cooling coils. It is not recommended for indoor use and it should not be used on evaporator coils.

Alka-Brite Plus 4X is a new concentrate version available in a ready-to-use quart bottle. One concentrate quart equals one gallon traditional Alka-Brite Plus (at 4:1 dilution use). Alka-Brite Plus 4X takes less space on truck, is easy to carry on roofs, and has cleaner connecting – no more pouring or spilling. The specially developed packaging has a dilution insert assembly; simply use what is needed, cap bottle and use for another job. The product ships as a limited quantity – easier to get to the job site. Alka-Brite Plus 4X requires the Clean Connect Sprayer.

Directions

This product must be used in accordance to the following directions by HVACR professionals only.

At the coil to be cleaned, open the bottle cap of Alka-Brite 4X. When opening the bottle, a small amount of residue might be present under the cap due to shipment – this is normal.
Hook the desired cleaning attachment to the Clean Connect Sprayer until it snaps firmly into place.
Hook up water supply with a water hose to the Clean Connect Sprayer, and open access valve to allow flow to sprayer.
Facing the coil, grab the bottle of the sprayer, without depressing handle, and the spray accessory end. Toggle to clean mode on sprayer (chemistry beaker image) while depressing the Clean Connect Sprayer handle to dispense the cleaner on the dirty outdoor coil. Allow dispensed cleaner to work for 5-10 minutes on the coil before rinsing.
Hook up the standard hose assembly until this assembly snaps firmly into place.
Toggle to rinse mode on sprayer (bucket image) and rinse coil thoroughly with water.
If the cleaner bottle was emptied, properly discard. If cleaner remains in the bottle, simply remove from the Clean Connect Sprayer and cap bottle so it can be used for a future cleaning.
Close access valve to stop water flow to sprayer, remove sprayer from hose and package Clean Connect Sprayer in supplied mesh nylon bag and store properly on vehicle to protect sprayer’s plastic components.
If desired, apply Cal-Shield, as a coil protectant by using a separate pump-up sprayer.
Return the equipment back to service. Warning: Never transport the Clean Connect Sprayer attached to coil cleaner bottle since leakage will occur.