Nu-Brite 4X Concentrate

Nu-Brite 4X Concentrate

SKU: 4291-90

No. 1 Coil Cleaner in the HVACR Industry!

Cuts through grease and grime better than acids

High foaming chemistry to lift dirt out of coil

Brightens the condenser coils extremely well

Available in traditional and concentrate formulas

Concentrate packages take up less space and are easier to carry or ship

Product Description

When choosing a coil cleaner, reach for the BLUE!
Nu-Brite is a non-acid, alkaline-based product for cleaning and brightening air cooled condensers. It is formulated with the best available foaming detergents and chelants to quickly penetrate and dissolve greasy dirt and grime and foam it right out of the coil. The safer alternative to acids.

For cleaning and brightening air cooled condensers and other finned heating and cooling coils located outside. It is an alkaline based cleaner that does all that an acid will do without the danger of an acid. Nu-Brite’s state-of-the-art surfactants and cleaners instantly penetrate and lift layers of oily grime and corrosive deposits from the coil. Its foaming action pushes this loosened debris out of hard-to-reach areas restoring equipment to peak efficiency. It is not recommended for indoor use.

Nu-Brite 4X is a new concentrate version available in a ready-to-use quart bottle. One concentrate quart equals one gallon traditional Nu-Brite (at 4:1 dilution use). Nu-Brite 4X takes less space on truck, is easy to carry on roofs, and has cleaner connecting – no more pouring or spilling. The specially developed packaging has a dilution insert assembly; simply use what is needed, cap bottle and use for another job. The product ships as a limited quantity –easier to get to the job site. Nu-Brite 4x requires the Clean Connect Sprayer.

Directions

This product must be used in accordance to the following directions by HVACR professionals only.

At the coil to be cleaned, open the bottle cap of Nu-Brite 4X. When opening the bottle, a small amount of residue might be present under the cap due to shipment – this is normal.
Hook the desired cleaning attachment to the Clean Connect Sprayer until it snaps firmly into place.
Hook up water supply with a water hose to the Clean Connect Sprayer, and open access valve to allow flow to sprayer.
Facing the coil, grab the bottle of the sprayer, without depressing handle, and the spray accessory end. Toggle to clean mode on sprayer (chemistry beaker image) while depressing the Clean Connect Sprayer handle to dispense the cleaner on the dirty outdoor coil. Allow dispensed cleaner to work for 5-10 minutes on the coil before rinsing.
Hook up the standard hose assembly until this assembly snaps firmly into place.
Toggle to rinse mode on sprayer (bucket image) and rinse coil thoroughly with water.
If the cleaner bottle was emptied, properly discard. If cleaner remains in the bottle, simply remove from the Clean Connect Sprayer and cap bottle so it can be used for a future cleaning.
Close access valve to stop water flow to sprayer, remove sprayer from hose and package Clean Connect Sprayer in supplied mesh nylon bag and store properly on vehicle to protect sprayer’s plastic components.
If desired, apply Cal-Shield, as a coil protectant by using a separate pump-up sprayer.
Return the equipment back to service. Warning: Never transport the Clean Connect Sprayer attached to coil cleaner bottle since leakage will occur.